Table of Contents
Advertisement
push button to confirm.
3. Select the transmitter (collar) position you wish to set –
the MENU push button.
4. Select
5. By using
Confirm the selection by long pressing the MENU button.
6. Select the type or volume of the tone.
7. By repeatedly pressing
Stimulation impulse (IMPULSE):
This feature enables to activate warning in the transmitter (collar) in the form of safe
stimulation impulses transmitted by the two contact points. Stimulation impulses do
not hurt the dog. Impulse is very unpleasant to the dog, and consequently, will soon
make connection between the oral command, acoustic signal and uncomfortable
feeling on the neck.
Setting the pulse size is done in the MENU in the same way as selecting the tone
type and volume.
Select
where 0 means no impulse, 1 is the lowest impulse strength and 15 is the highest.
This command is sent to the transmitter (collar), which is selected on the receiver
(handset) navigation main panel by simultaneously pressing the
buttons.
Light feature (flash):
The light feature may be used to locate the dog in the dark. The function is activated
in MENU. The start-up procedure is the same as for the selection of the acoustic
signal volume strength, with the difference that in Point 4,
in Point 5,
8.3 Compass feature – determining the North
The N symbol indicates the direction of the magnetic north. If the two arrows are
simultaneously lit, direction to the North is between them.
8.4 FENCE – circular fence/circular acoustic boundary
The FENCE feature alerts you when the dog moves beyond the set area boundary,
which is adjustable within the range of 30 m to a maximum of 2 km from the receiver.
Circular fence may be activated for more dogs; settings are stored for each dog
separately.
If the dog moves beyond the set boundary, the receiver will emit long intermittent
beeping and the circle, for this dog, located under the direction indicator will flash
on the receiver display. To find out which dog has crossed the set boundary, switch
between paired transmitters until you find the flashing circle.
When this feature is turned on, the receiver must have good GPS signal:
1. Select the dog number for which you wish to enable FENCE on the main navigation
18
arrows, long press the MENU push button.
by using
/
/
arrows select
to set the tone type, or
return to the main screen.
as per Point 4 and select the impulse strength as per Point 5,
(ONLY GPS X25T/X25TB)
is selected.
to set the volume of the training/location tone.
(ONLY GPS X25T/X25TB)
to
; long press
or
or
+ FENCE push
is selected and
Advertisement
Table of Contents
