Hanging The Unit Up - Biddle DF2 Installation, Operating And Maintenance Manual

DF M
ANUAL
2.4

Hanging the unit up

Installation, Operating And Maintenance Manual version 1.0 (16-08-2023)
6. Switch the mains supply on and check that the unit is
working properly.
7. Connect the unit to any building management systems (if
required).
General instructions
Some parts of this section only apply to certain models.
Where this is the case, it will be indicated. If no specific model
is referred to, then the description applies to all models.
n
Note:
Make sure that you perform all installation
operations that are applicable to your unit.
Check the type plate and consult the manual if in
doubt about the model or type of your unit.
n
Note:
During the installation period, protect the unit
against damage and penetration of dust, cement, etc.
You can, for instance, use the packaging for
protection.
See also:
1.4 "Hanging the unit up" on page 3
1.5 "Connecting the unit to the central heating system" on
page 7
1 "Connecting the mains supply" on page 1
1.7 "Installing the control panel and external controls" on
page 12
1.8 "Finishing the unit" on page 20
1.9 "Power on and check operation" on page 22
2.4.1 Determining the location of the unit
• Make sure that the structure from which the unit is about
to be suspended can bear at least 4 times the weight of the
unit.The unit's weight is indicated on its type plate.
en
I
NSTALLATION
en-13