Biddle DF2 Installation, Operating And Maintenance Manual page 15

DF M
ANUAL
Installation, Operating And Maintenance Manual version 1.0 (16-08-2023)
2.4.2 Mounting the optional remote control
1. Identify a suitable place for the wall controller to be
mounted. This should be away from direct sunlight in a
place where tampering is not likely to affect the operation
of the unit. If the sensor in the wall controller is being used
to control the heating, then ensure it's sufficiently exposed
to the room temperature.
2. Install the control cable between the unit and where the
wall controller is to be positioned.
3. Open the casing.
4. Affix the back of the casing to the wall using 2 screws over
the cable.
5. Plug the cable into the connector on the back of the wall
controller.
6. Close the casing.
7. Terminate the other end of the cable into the top of the
unit.
n
Note:
Leave approximately 20cm of slack in the cable
above the unit to make serving the unit easier in the
future.
2.4.3 Suspending and securing the unit
1. Position the four M8 screw threads. Make sure the
threaded rods are perpendicular.
Dimensions for free-hanging and recessed units
SIZE TYPE
a all DF F, R
2
b all DF F, R
2
c all DF F, R
2
d DF 100-F, 100-R
2
DF 150-F, 100-R
2
DF 200-F, 200-R
2
DF 250-F, 250-R
2
I
NSTALLATION
DIMENSIONS
as needed
35 mm
290 mm
896 mm
1396 mm
1896 mm
2396 mm
en-15
en