Direct Wall Mounting - Uniden XC815 Owner's Manual

Select a location away from electrical cables,
pipes, or other items behind the mounting
location that could cause a hazard when inserting
screws into the wall.
Make sure the wall material is capable of
supporting the weight of the base and handset.
Use #10 screws with anchoring
devices suitable for the wall material
where the base will be placed.
1. Insert two mounting screws
3 inches apart. Allow
15
16
about of an inch between
3
16
the wall and screw heads for
mounting the phone.
2. Plug the AC adapter into
the base.
3. Place the AC adapter cord
inside the molded channel.
4. Plug one end of the long
telephone cord into the
TEL LINE jack on the
base.
5. Place the cord inside the
molded channel on the
bottom of the base.
6. Place the base on the
screws and push down
until it's firmly seated.
7. Plug the other end of the telephone line cord
into the wall jack.
8. Plug the AC adapter into a standard 120 VAC
wall outlet.
Note: Do not use an outlet controlled by a
wall switch.
Setting the Handset Retainer
The handset retainer holds the handset in place if
your phone is mounted on a wall. The steps
below describe how to remove and replace the
retainer so that the tab faces up.
1. Push up on the
handset retainer on
the base, and slide
the tab out.
2. Flip the retainer
over so the tab
faces up.
3. Put the retainer
back into its slot
on the base.
4. Push down on
the handset retainer
until it snaps into
place.
6