Troubleshooting; Specifications - Uniden XC815 Owner's Manual

If your XC800 Series Cordless Telephone is not performing to your expectations, please try these simple
steps. If you are still unable to resolve the problems, contact Uniden Customer Service at (800) 297-1023,
8:00 a.m. to 5:00 p.m. Central, Monday through Friday.
Problem
Status light won't come on when handset is placed in base.
Audio sounds weak and/or scratchy.
Can't make or receive calls.
Handset doesn't ring or receive a page.
Hear only continuous static from handset and phone will not
turn off.
General
The XC800 Series complies with FCC Parts 15 and 68.
Frequency Control
Modulation
Operating Temperature -10 to 50 C
Base
Receive Frequency
Transmit Frequency 43.72 to 46.97 MHz
Power Requirements 120 VAC 60 Hz
Size
Weight
Handset
Receive Frequency
Transmit Frequency 48.76 to 49.99 MHz
Power Requirements Rechargeable Ni-Cd Battery Pack
Size
Weight
Battery (BT-801)
Specifications, features, and availability of optional accessories are all subject to change without
prior notice.

Troubleshooting

Specifications

PLL
FM
48.76 to 49.99 MHz
3 VAC
7-1/4 in. (H) x 4-3/4 in. (W) x 2-1/2 in. (D)
Approx. 11.1 oz.
43.72 to 46.97 MHz
7-1/4 in. (H) x 2-1/4 in. (W) x 2 1/2 in. (D) (w/o antenna)
Approx. 10 oz. (including battery)
Capacity 300 mAh, 2.4V
Talk Mode 8 hours
Standby Mode 14 days
Make sure AC adapter is plugged into the base and wall outlet.
Make sure handset is properly seated in base.
Make sure that the charging contacts on the handset and base are clean.
Make sure that the base antenna is fully extended and vertical.
Move the handset and/or base to different locations and try again.
C
Press the button to select another channel.
Check both ends of the base telephone line cord.
Make sure the AC adapter is plugged into the base and wall outlet.
Disconnect the AC adapter for a few minutes, and then reconnect it.
Nickel-Cadmium battery pack may be weak. Charge the battery on the base for
15–20 hours.
Extend the base antenna vertically.
The handset may be too far away from the base.
Place the base away from noise sources.
The digital security code may be erased. Set the digital code.
The power has been interrupted during a call.
Restore power to the base. Make sure the phone is not plugged into an outlet
controlled by a wall switch.
If a power failure has occurred and power will be out for some time, remove
the battery from the handset. This will prevent the battery from completely
discharging.
11
Suggestion