Technical Description - Nordica INSERTO 80 WIDE 5.0 User Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 19

TECHNICAL DESCRIPTION

The appliance La NORDICA is suitable to heat living spaces for some periods.
As fueL, wOOD LOgs ARe useD. THE APPLIANCE wORkS AS AN INTERmITTENT OPERATINg APPLIANCE.
The appliance is made up of a steel chamber completely soldered and hermetic.
The hearth is totally sheathed with single cast-iron sheets and refractory plates (NORDIKeR). Its back is extractable. Thanks to calibrated holes,
made on the same back, it is guaranteed a supply of pre-heated air inside the hearth, thus obtaining a post-combustion which increases the
efficiency and reduces the emission of the unburnt gases. Inside it there is a turning and extractable grate.
Below the hearth door will be found an extractable ash-drawer with a closing door.
The inside smoke plate, reflects the fire radiation and increases the internal temperature of the combustion chamber. This process together
with the exhaust gases flows, makes optimal the combustion and improves the efficiency (see
The hearth is equipped with a panoramic door with ceramic glass (resistant up to 700 °C). This allows a wonderful view on the burning flames.
furthermore, it is thus avoided the output of sparks and smoke.
THE HEATINg Of THE ENvIRONmENT IS mADE by IRRADIATION: through the panoramic glass and the external hot surfaces of the stove,
the heat is radiated into the environment (see chapter CALCuLATION Of THe THeRMAL POweR).
ACCESSORIES
THe DeVICe Is equIPPeD wITH RegIsTeRs Of PRIMARy AND seCONDARy AIR, wITH wHICH IT Is POssIBLe TO ADjusT THe COMBusTION
AIR.
1A - PRImARy air register
(Picture
with the air register located under the door of the hearth (on the left), it is possible to adjust the air flow through the ash drawer and the
grating in direction of the fuel. The primary air is necessary for the combustion process. In order to open the passage of primary air the
lever should be completely pulled. The ash drawer has to be emptied regularly, so that ash cannot hinder the intake of primary air for the
combustion. Primary air is also necessary to keep fire live.
During the combustion of wood, the primary air register must be opened only a few, since otherwise the wood burns quickly and the
device can overheat (see chapter NORMAL OPeRATION).
2A - SECONDARy air register
under the door of the hearth (on the right) there is a secondary air register.
This register must be opened (and therefore the lever completely pushed), in detail, for the combustion of wood, so that unburnt carbon
can be subject to a post-combustion, increasing the yield and assuring the cleaning of the glass (see chapter NORMAL OPeRATION).
It is possible to get the combustion air directly from outside through a flexible tube fireproof NOT furnished (see chapter
VeNTILATION HOOD OR ADjACeNT LOCAL) .
THE ADjuSTmENT Of THE REgISTERS NECESSARy TO REACH THE RATED CALORIfIC yIELD is the following one:
INSERTO 80 wIDE 5.0
fOR CORRECT OPERATION of the appliance, air must always be able to pass through the hole in the bottom of the appliance by
removing the half-cover
The half-cover
Picture 11
If the passage of air through the hole in the bottom of the unit is NOT guaranteed, the front panel muST bE REmOvED
It is possible to get the combustion air directly from outside through a flexible tube fireproof NOT furnished (see chapter
VeNTILATION AND AeRATION Of THe INsTALLATION PReMIses).
POKER
seRIes
* see instructions manual CONNeCTION AND MAINTeNANCe Of VeNTILATION OPTIONAL.
8)
8)
(Picture
Hourly consumption (kg/h)
3,23
Picture 11
- b .
- A must NOT be removed ONLy when installing the wIND AIR ventilation kit.
Air channelling
gLOvE
FITTING
seRIes
PRImARy air
Picture 8
- b
ENGLISH
Picture
13).
(Picture 11
- C)
seRIes
SECONDARy air
Picture 8
- b
Ventilation
KIT WIND AIR
OPTIONAL*
TERTIARy AIR
PRe-ADjusTeD
Picture 11
- b.
25

Advertisement

Table of Contents
loading

Table of Contents