Remote Operation - Uniden DCT6485 Series Owner's Manual

Remote Operation

note
•The time stamp will not
be heard until you have
set the time. See
"Setting the Time" on
page 54.
•The system will only
playback messages for
four minutes and then it
returns to the command
waiting mode. To
continue playing your
messages, press 0 then 2
again within 15 seconds.
•If you enter an incorrect
PIN code three times,
you will hear a beep and
the system will return
to standby.
•During the remote
operation, appears
on the base.
•If the answering system
is recording an
incoming message, the
recording operation is
canceled when you
access your answering
system remotely.
•For your convenience a
remote operation card is
provided for you to use
while away from home
(refer to page 83).
[ 6 2 ] T H E I N T E G R A T E D A N S W E R I N G D E V I C E
You can check, play, or delete messages, even record a new greeting message from a remote
location (when you are away from home, or from another room using a handset).
Additionally, you can turn On or Off your answering system remotely.
Remote access away from home
You can operate your answering system from a remote location using any
touch-tone telephone.
1) Call your telephone number and wait for the system to answer. If the answering system is
off, it will answer after about 10 rings and sounds a series of beeps.
2) During the greeting message (or a series of beeps when the answering system is off),
press 0 and enter your PIN code within 2 seconds (see "Setting a PIN Code" on page 24
or 54).
3) The answering system announces the current time and the number of messages stored in
memory. You hear "To play incoming messages, press zero-two. For help, press one-zero."
You will hear a beep.
4) Enter a command within 15 seconds, each command there after must be entered within 2
seconds. You may select a command from the following chart:
Command Function
0 1
then Repeat a Message*
0 2
then Playing incoming Messages
0 3
then Skipping a Message
0 4
Deleting a Message
then
0 5
Stop Operation
then
Command Function
0 6
then Answering System On
0 7
then Memo Record/Stop**
0 8
then Greeting Message Record/Stop**
0 9
Answer System Off
then
1 0
Help Guidance
then
w w w . u n i d e n . c o m