Olympus UHI-4 Instructions Manual page 46

Chapter 3 Installation and Connection
40
• When attaching the cylinder hose to the CO
rear panel of the UHI-4, unbend the cylinder hose and tighten
the hose holding by hand (see Figure 3.2). Otherwise, there
is a fear of significant gas leakage.
Incorrect
Figure 3.2
• Cylinder hose for UHI-3 is sold separately. Please purchase
a cylinder hose for UHI-3 compatible with your gas cylinder
type. For specific details, please contact Olympus.
• Attach a cylinder holder on an Olympus trolley to secure the
CO
Instructions manual for the cylinder holder used.
T1/TC series
WM-NP1, WM-WP1, WM-DP1
WM-NP2, WM-DP2
• The dedicate trolley (WM-NP2/WM-DP2) is required to use
this device in combination with the cylinder hose with switch
over valve (MAJ-1985, MAJ-1986). When using the cylinder
hose with switch over valve, refer to the instruction manual.
 For EU, Australian and New Zealand market
Cylinder hose must be attached to UHI-4 by Olympus personnel on installation
time. Enclosed nut cover will be fixed at the place where cylinder hose and
insufflator are connected by Olympus personnel.
HIGH FLOW INSUFFLATION UNIT UHI-4
cylinder before use. For installation, also refer to the
2
Trolley
gas inlet on the
2
Correct
Applicable cylinder holders
MH-509, MH-510, MH-511
MAJ-188, MAJ-1614
MAJ-1639, MAJ-1650, MAJ-1653