Table of Contents
Advertisement
REMOVING A REAR LAMP
ASSEMBLY
1.
Make sure the headlamps and rear
lamps are off.
2. Open the tailgate to access the rear
lamp assemblies.
E364483
3. Remove the two bolts from the tail
lamp assembly. Carefully pull the lamp
assembly from the tailgate pillar.
4. Disconnect the electrical connector
from the bulb.
5. To install, reverse the removal
procedure.
CHANGING A HEADLAMP BULB
WARNING: Make sure the bulbs
have cooled down before removing
them. Failure to follow this warning could
result in serious personal injury.
Accessing and Replacing the Low
Beam Headlamp Bulbs
1.
Make sure the headlamps are off.
2. Remove the scrivet from the modesty
panel.
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Maintenance
3. Remove the modesty panel section.
E363282
4. Remove the scrivet from the front
fender and the hardware from the
bolster.
E363283
5. Using a screwdriver loosen, but do not
remove, the three screws by turning
them two full turns.
419
Advertisement
Table of Contents
Troubleshooting
