Table of Contents
Advertisement
This equipment complies with FCC
radiation exposure limits set forth for an
uncontrolled environment. End Users must
follow the specific operating instructions
for satisfying RF exposure compliance. This
transmitter must be at least 8 in (20 cm)
from the user and must not be co-located
or operating in conjunction with any other
antenna or transmitter.
PROGRAMMING THE GARAGE
DOOR OPENER
To clear all stored codes in the garage door
opener in your vehicle, use the clear
function. To override one button, use the
reprogram function.
Note: Make sure that the garage door and
security device are free from obstruction
when you are programming. Do not program
the system with the vehicle in the garage.
Clearing the Garage Door Opener
E188213
To clear all stored codes in the garage door
opener in the vehicle:
1.
Press and hold the outer two function
buttons simultaneously for
approximately 10 seconds until the
indicator above the buttons flashes
rapidly.
2. When the indicator flashes, release the
buttons.
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Garage Door Opener
(If Equipped)
Note: This clears all stored codes. You
cannot erase individual buttons.
Note: You can program a maximum of
three devices. To change or replace any of
the three devices after they have been
initially programmed, you must either clear
all codes, or reprogram each individual
button.
Note: We recommend that upon the sale
or lease termination of your vehicle, you
erase the programmed function buttons for
security reasons.
Reprogramming the Garage Door
Opener
If a button on your garage door opener has
already been programmed, you can
override it. To program a device to a
previously trained button:
1.
Press and hold the desired button for
approximately 20 seconds until the
indicator begins to flash.
2. Without releasing the button, proceed
to Step 3 of Programming the
Garage Door Opener to your
Handheld Transmitter.
Programming the Garage Door
Opener to your Handheld
Transmitter
Note: The programming steps below
assume you are programming a HomeLink
that was not previously programmed. If your
HomeLink was previously programmed, you
may need to clear or reprogram your
HomeLink buttons.
Note: Put a new battery in the handheld
transmitter. This allows for quicker training
and accurate transmission of the
radio-frequency signal.
Note: Make sure that the garage door and
security device are free from obstruction
when you are programming. Do not program
the system with the vehicle in the garage.
158
Advertisement
Table of Contents
Troubleshooting
