Switching Pre-Collision Assist On And Off; Locating The Pre-Collision Assist Sensors - Ford RANGER 2024 Owner's Manual

E309750
SWITCHING PRE-COLLISION
ASSIST ON AND OFF
1.
Press the button on the
E386797
touchscreen.
2. Press Driver Assistance.
3. Press Pre-Collision Assist.
4. Switch the feature on or off.
Adjusting the Pre-Collision Assist
Settings
You can adjust the following settings by
using the touchscreen controls in the
pre-collision assist menu:
• Change alert sensitivity to one of three
possible settings.
• If required, switch automatic
emergency braking on or off.
• If required, switch the entire
pre-collision assist feature on or off.
Note: Automatic emergency braking
switches on every time you switch the
ignition on.
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Pre-Collision Assist
LOCATING THE PRE-
COLLISION ASSIST SENSORS
If a message regarding a blocked sensor
or camera appears in the instrument
cluster, something is obstructing the radar
signals or camera images. The radar sensor
is located behind the fascia cover in the
center of the lower grille. If a sensor or
camera is blocked, the system may not
function, or performance may reduce. See
Pre-Collision Assist – Information
Messages (page 316).
Note: Proper system operation requires the
camera have a clear view of the road. Have
any windshield damage in the area of the
camera's field of view repaired.
Note: If something hits the front end of your
vehicle or damage occurs and your vehicle
has a radar sensor, the radar sensing zone
could change. This could cause missed or
false vehicle detections. Have your vehicle
serviced to have the radar checked for
proper coverage and operation.
312
E365303
1. Camera.
2. Radar sensor (if equipped).