Table of Contents
Advertisement
E188212
3. Press and hold one of the three
HomeLink function buttons you want
to program for two seconds, then
release.
4. Repeat Step 3. Depending on your
brand of garage door opener, you may
need to repeat this sequence a third
time.
Additional assistance can be found online
at
www.homelink.com/Ford
the toll-free help line at 1-800-355-3515.
Programming the Garage Door
Opener to your Gate Opener Motor
Gate Operator / Canadian
Programming
Canadian radio-frequency laws require
transmitter signals to time-out (or quit)
after several seconds of transmission –
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
time-out in the same manner.
Note: If programming a garage door opener
or gate operator, it is advised that you
unplug the device during the cycling process
to prevent possible overheating.
1.
Press and release your handheld
transmitter, every two seconds, until
the HomeLink indicator flashes rapidly
or is continuously on.
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Garage Door Opener
or by calling
(If Equipped)
2. Release the handheld transmitter
button.
3. Press and hold the HomeLink function
button you want to program for two
seconds, then release. You may need
to do this twice to activate the door.
Note: If the indicator stays on, the
programming is complete.
Note: If the HomeLink indicator flashes
rapidly, repeat Step 3.
4. To program additional buttons, repeat
Steps 1–4.
Additional assistance can be found online
at
www.homelink.com/Ford
the toll-free help line at 1-800-355-3515.
GARAGE DOOR OPENER
ADDITIONAL ASSISTANCE
Video Setup Instructions
Universal Garage Door Opener: HomeLink
Universal Garage Door Opener: HomeLink
for Genie Intellicode 2
Universal Garage Door Opener Homelink for
Genie Intellicode
Additional assistance can be found online
at
www.homelink.com/Ford
the toll-free help line at 1-800-355-3515.
160
or by calling
or by calling
Advertisement
Table of Contents
Troubleshooting
