Table of Contents
Advertisement
BRAKE PRECAUTIONS
Wet brakes result in reduced braking
efficiency. Gently press the brake pedal a
few times when leaving a car wash or
driving from standing water to dry the
brakes.
Note: Depending on applicable laws and
regulations in the country where your vehicle
was originally built, the stoplamps could
flash during heavy braking. The hazard
warning flashers could also turn on when
your vehicle comes to a stop.
ANTI-LOCK BRAKING SYSTEM
ANTI-LOCK BRAKING SYSTEM
LIMITATIONS
The anti-lock braking system does not
eliminate the risk of crash when:
•
You drive too closely to the vehicle in
front of you.
•
Your vehicle is hydroplaning.
•
You take corners too fast.
•
The road surface is poor.
Note: If the system activates, the brake
pedal could pulse and travel further.
Maintain pressure on the brake pedal.
ANTI-LOCK BRAKING SYSTEM
INDICATORS
This system helps you maintain steering
control during emergency stops by keeping
the brakes from locking.
If the warning lamp illuminates
when you are driving, this
E67020
indicates a malfunction. Your
vehicle continues to have normal braking
without the anti-lock brake system
function. Have your vehicle checked as
soon as possible.
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Brakes
The warning lamp also momentarily
illuminates when you switch the ignition
on to confirm the lamp is functional. If it
does not illuminate when you switch the
ignition on, or begins to flash at any time,
have the system checked by an authorized
dealer.
The warning lamp illuminates
when you engage the parking
E270480
brake and the ignition is on.
If it illuminates when your vehicle
E67024
is moving, make sure the parking
brake is disengaged. If the
parking brake is disengaged, this indicates
low brake fluid level or a brake system
fault. Have your vehicle checked as soon
as possible.
The warning lamp also momentarily
illuminates when you switch the ignition
on to confirm the lamp is functional. If it
does not illuminate when you switch the
ignition on, or begins to flash at any time,
have the system checked by an authorized
dealer.
BRAKE OVER ACCELERATOR
In the event the accelerator pedal
becomes stuck or entrapped, apply steady
and firm pressure to the brake pedal to
slow the vehicle and reduce engine power.
If you experience this condition, apply the
brakes and bring your vehicle to a safe
stop. Move the transmission to park (P),
switch the engine off and apply the parking
brake. Inspect the accelerator pedal for
any interference. If none are found and the
condition persists, have your vehicle towed
to the nearest authorized dealer.
LOCATING THE BRAKE FLUID
RESERVOIR
See Under Hood Overview (page 403).
215
Advertisement
Table of Contents
Troubleshooting
