Fcc Information - Ultratec Minicom IV User Manual

FCC Information

The Minicom IV has been tested and
found to comply with the specifications
for a Class B digital device pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates and uses radio
frequency energy and if not installed
and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a
particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
Minicom IV and the receiver.
• Connect the Minicom IV to an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Should you experience trouble with this
TTY equipment, please contact:
Ultratec National Service Center
5901 Research Park Blvd.
Madison, WI 53719
email: service@ultratec.com
For repair or warranty information,
please contact Ultratec Inc. Customer
Service at (608) 238-5400 (V/TTY). If
the equipment is causing harm to the
telephone network, the telephone
company may request that you
disconnect the equipment until the
problem is resolved.
Other than replacing the batteries, the
Minicom IV does not have any user-
serviceable parts. Modification or changes
to the Minicom IV not expressly
approved by Ultratec, Inc. can void your
authority to operate the TTY.
F C C I N F O R M A T I O N • 25