Turning Turbo Code; Ctrl + Shift + B - Ultratec Minicom IV User Manual

Turning off Turbo Code interrupt
You can stop the other person from sending interrupts to you by
following the steps below:
1.Press the options key (
CASE on the display.
2.Press the
3.Press the
4.Press the
Turning off interrupt does not affect outgoing interrupts. You can
still send an interrupt to the other person.
Turning Turbo Code on and off
Turbo Code is used automatically during a call. However, you can
turn Turbo Code off at any time by pressing
Minicom IV will use Turbo Code again after you turn the power off.
You can also turn off Turbo Code so that the Minicom IV will not
use it until you turn Turbo Code on again. Follow these steps:
1.Hold down the
(UP/LOW) CASE on the display.
2.Press the
3.Press the
4.Press the
press the
Follow the steps above to turn Turbo Code on again.
14 • A D V A N C E D
Ctrl
key until you see INTERRUPT (ON) on the display.
Return
to change the setting to OFF.
Spacebar
key to save the new setting and leave options.
Esc
key and press the
Ctrl
key until you see TURBO CODE (ON) on the display.
Return
to change the setting to OFF.
Spacebar
key to save the new setting and leave options or
Esc
key to save and go to the next option.
Return
C A L L I N G
+ ). You will see PRINT (UP/LOW)
3
Ctrl
key. You will see PRINT
3
+
Ctrl 3
+ +
Shift B
+ +
. The
Ctrl Shift B