Related Manuals for Speco VLD9
Summary of Contents for Speco VLD9
- Page 1 VLD9 /VLD9M USER MANUAL Thank you for purchasing our product. Speco Technologies is constantly developing and improving products. We reserve the right to modify product design and specifications without notice and without incurring any obligation.
- Page 2 ■ If the product does not work properly, please contact the dealer or where the product was purchased. Speco Technologies is not responsible for any problems caused by improper operation or repair. ■ Do not expose the unit to heavy stress, violent vibration or long-term exposure to water and humidity during transportation, storage, and/or installation.
-
Page 3: Installation
You’d better install back the lens cover or lower dome less than 4 hours after removing it. The mounting types of cameras are only for reference. ►Mounting for VLD9 1. Drill the screw holes and the cable hole on the wall according to the drill template. - Page 4 2. Align the gap of the trim ring with the microphone by turning the trim ring with fingers. Then remove the trim ring from the gap of the camera. 3. Loosen the screws to open the lower dome. Then route and connect the cables. 4.
- Page 5 ►Mounting for VLD9M 1. Drill the screw holes and the cable hole on the wall according to the drill template. 90.2mm ∅4.6 90.2mm 2. Align the gap of the trim ring with the microphone by turning the trim ring with fingers. Then remove the trim ring from the gap of the camera.
- Page 6 5. Three-axis adjustment. Before adjustment, preview the image of the camera on a monitor and then adjust the camera according to the figure below to get an optimum angle. Pan 0°~345° Tilt 0°~77° Turn Rotation 0°~345° 6. Install the lower dome back to the camera and fix it with screws. Then put the trim ring onto the lower dome and then rotate it clockwise until it is locked.
-
Page 7: Specifications
Specifications Models VLD9 VLD9M Specifications Camera Image Sensor 1/2.8" CMOS Resolution Image size 1920×1080 Video Output AHD/TVI/CVI/CVBS (*camera comes defaulted to HD-TVI) Image System Electronic Shutter PAL/NTSC IR Range (feet) 33~66 65~98 Frame Rate 30fps(60Hz); 25fps(50Hz) Min. Illumination 0.001lux @F1.2, AGC ON; 0 lux with IR Lens 2.8 mm... - Page 8 Model: VLD9 /VLD9M Federal Communications Commission (FCC) Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the VLD9 and is the answer not in the manual?
Questions and answers