The Pressure switch turns on within a set pressure range (from P1L to P1H) during window comparator
mode. Set P1L, the lower limit of the switch operation, and P1H, the upper limit of the switch operation and
WH1 (hysteresis) following the instructions given on page 21.
(When reversed output is selected, the sub display (left) shows [n1L] and [n1H].)
Please refer to the "List of output modes" on page
operation.
∗: Set OUT2 in the same way.
Setting of the normal/reverse output switching and hysteresis/window comparator mode switching are performed with the function
selection mode [F 1] OUT1 setting and [F 2] OUT2 setting.
31
for the relationship between the set values and
-22-
No.PS※※-OMV0004-H
Need help?
Do you have a question about the ISE70G-N02-L2 and is the answer not in the manual?