Table of Contents
Advertisement
Installation
Installing a surface-mounted hob with Plug&Play
Create the worktop cut-out. Remember to maintain the minimum safety dis-
tances (see "Installation – Safety distances").
Cut the top of the drilling template to the thickness of your worktop. Depending
on the installation depth, place the correct drilling template on top of the hous-
ing unit rear wall. Use the drilling template to create a cut-out for the Plug&Play
adapter.
Installation depth
23,8 cm
24,8 cm
1
The template is supplied with the appliance.
2
The templates can be found on the Miele homepage.
If you do not have a drilling template, see "Installation – Rear wall cut-out
without drilling template".
Seal any cut surfaces on wooden worktops with a special varnish, silicone
sealant or resin to prevent the wood from swelling as a result of moisture in-
gress. The sealant must be heat-resistant.
Make sure that the sealant does not come into contact with the top of the work-
top.
Attach the sealing strip provided underneath the edge of the hob. Do not apply
the sealing strip under tension.
The Plug&Play adapter may break off.
When placing the hob on the worktop, make sure that it is not placed on top of
the Plug&Play adapter.
Connect the Plug&Play adapter to the hob and set the adapter position.
Feed the mains connection cable for the hob down through the worktop cut-out.
Remove the protective foil from the adhesive tape at the end of the Plug&Play
adapter.
Place the hob centrally in the cut-out. When doing this, make sure that the seal
of the appliance sits flush with the worktop on all sides. This is important to en-
sure an effective seal all round.
96
Drilling template num-
1
2
ber
2
3a
Adapter position
2
3
Advertisement
Table of Contents
