Page 3
This manual is released by Vecow Co., Ltd. for reference purpose only. All product offerings and specifications are subject to change without prior notice. It does not represent commitment of Vecow Co., Ltd. Vecow shall not be liable for direct, indirect, special, incidental, or consequential damages arising out of the use of the product or documentation or any infringements upon the rights of third parties, which may result from such use.
1.1 Overview 1.2 Features 1.3 Product Specification 1.4 Block Diagram 1.5 Mechanical Dimension CHAPTER 2 GETTING TO KNOW YOUR VCOM-BASE 2.1 Packing List 2.2 Front Panel I/O Functions 2.3 Carrier Board Connectors 2.4 Carrier Board Jumper Settings CHAPTER 3 SYSTEM SETUP 3.1 How to Install Your COM Module...
GENERAL INTRODUCTION 1.1 Overview ® Vecow COM Express product adheres to the PICMG standard. The Vecow ® VCOM-BASE COM Express Type 6 Reference Carrier Board comes in an ® ATX form factor and conforms to the COM Express Carrier Design Guides. It supports up to 3 PCIe slots and up to 3 independent displays.
2.2 Front Panel I/O Functions In Vecow's VCOM-BASE series family, all I/O connectors are located on the front panel. Most of the general connections to the computer device, such as audio, USB, RJ45,DVI-D, Display Port, SIM Card, Serial Port and VGA are placed on the front panel 2.2.1 Audio Connector...
Page 14
There are 4 USB 3.1 Gen1 connections available supporting up to 5GB per second data rate in the front side of VCOM-BASE. They are also compliant with the requirements of Super Speed (SS), high speed (HS), full speed (FS) and low speed (LS).
Page 15
You will need a DVI-D cable when connecting to a display device. 2.2.5 DISPLAY PORT VCOM-BASE supports single Display Port and up to 4096 x 2304 pixels resolution. 2.2.6 VGA VCOM-BASE supports single VGA and up to 1920 x 1200 pixels resolution.
Page 18
Fan speed sensor Fan PWM 2.3.3 CON1, J1: LVDS Connector CON1 VCOM-BASE supports dual-channel 24-bit LVDS display and up to 1920 x 1200 pixels resolution. The pin assignments of LVDS are listed in the following table : Pin No. Definition Pin No.
Page 21
2.3.6 CN10,CN11 : Internal USB2.0 CN10 CN11 The VCOM-BASE carrier board provides maxima eight expansion USB ports. The USB interface supports 480 Mbps transfer rate which comply with high speed USB specification Rev. 2.0. The pin assignments of CN10 and CN11 are listed in the following table: Pin No.
2.4 Carrier Board Jumper Settings 2.4.1 Front View of VCOM-BASE Main Board With Jumper Location The figure below is the top view of the VCOM-BASE main board. It shows the location of the jumpers. JRI_PWR1 LED12 JP10 JP19 JP27 JP18...
Page 46
2.4.11 JP10 : DDI3 Signals JP10 On VCOM-BASE carrier board, DDI3 Signals support front side DVI-D connector. Pin No. Function HDMI (Default) Display Port 2.4.12 JP5 : Super I/O To enable or disable Super I/O on the carrier board, the Express-BASE6 enables the carrier board ITE 8786E Super I/O, short pins 1-2 of Jumper JP5 by default.
Need help?
Do you have a question about the VCOM-BASE and is the answer not in the manual?
Questions and answers