ABB HT603545 Operation Manual page 90

Operation Manual / TPL76-C
8 Disassembly and assembly / 8.5 Removing cartridge group
© Copyright 2020 . All rights reserved.
Removing the compressor casing internal part
Remove two studs (74029 / 74026) at the point where the lifting
u
device (90190) will be fitted later.
Using press-off screws (90900), push apart the compressor casing in-
u
ternal part (76000) until the lifting device (90190/90195) can be at-
tached.
Slightly lift and then withdraw the compressor casing internal part in-
u
cluding the wall insert and diffuser.
Attach the support angle (90025) using screws (90021) and nuts
u
(74027).
Put down the compressor casing internal part including the wall in-
u
sert and diffuser on the support angle and an underlay.
Remove the O-ring (76040).
u
HZTL2485_EN Rev.G March 2020