Table of Contents
Advertisement
Operation Manual / TPL76-C
9 Taking out of operation at short notice / 9.2 Locking the rotor
Fitted assembly plate CV
33, CV 34
© Copyright 2020 . All rights reserved.
Put assembly/disassembly device (90020) over studs (74026) and lift-
u
ing device (90427).
Turn compressor wheel until holes in lifting device (90427) align with
u
holes in assembly/disassembly device (90020).
Fasten assembly/disassembly device to lifting device (90427) using
u
screws (94006).
Secure assembly/disassembly device (90020) to compressor housing
u
by screwing nuts (74027) onto studs (74026). (See also chapter Table
of tightening torques.)
CAUTION
Make sure all components are clean and free from grease.
HZTL2485_EN
Rev.G
March 2020
Advertisement
Table of Contents
