Cleaning The Compressor During Operation - ABB HT603545 Operation Manual

Operation Manual / TPL76-C
5 Maintenance / 5.3 Cleaning the compressor during operation

5.3 Cleaning the compressor during operation

Approval by enginebuilder
General
Cleaning interval
© Copyright 2020 . All rights reserved.
These instructions for wet cleaning only apply when cleaning is carried
out with clean water and under the precondition that the enginebuilder
approves the process.
The contamination of the compressor stage (compressor wheel, wall in-
sert and diffuser) depends on the degree of purity of the air that is
drawn in.
Deposits can form in the flow channels if salt, oil mist, exhaust gas or
dust are sucked in with the air.
Consequences of contamination:
¡
Impaired compressor efficiency
¡ Higher exhaust gas temperatures
¡
Increased fuel consumption
¡
Increased rotor unbalance
Periodic cleaning of the compressor during operation prevents or delays
any major increase in contamination. It does not, however, replace the
regular service work, during which the turbocharger is completely dis-
mantled and the compressor is cleaned mechanically.
The interval between periodic cleaning is very dependent on the operat-
ing conditions. In general, cleaning should be carried out every 25 ... 100
operating hours.
Should the specified cleaning intervals prove incompatible with engine
operation, please contact ABB Turbocharging.
HZTL2485_EN Rev.G March 2020