Prepare For Set Up - iCoolsport 5 Series Owner's Manual

Prepare for set up

To make setup as smooth as possible, please carefully follow the instructions outlined below. Do not use
the cooling unit until you have read and followed the advice in this owner's manual. Improper installation
or operation may result in equipment damage not covered by warranty.
Most important: Your Machine MUST have enough air flow front and back for safe proper cooling.
Unboxing
We strongly recommend keeping the original packaging of your
unit for as long as your warranty lasts. It can be used if you ever
re-locate the chiller and offers you peace of mind for transport.
To unpack, cut vertical straps and slowly remove cardboard lid.
You'll then see all your accessories in a foam block. Make sure
nothing is missing.
Pull out foam block and remove cardboard edges. Your chiller is
held by a zip tie on the bottom handle. Cut zip tie carefully and
remove Compact from its base.
Requirements of the room
Your Compact can be placed anywhere you want and may be
used in an outdoor area as long as it is not i direct rain or strong
sunlight. As with any appliance you must avoid very corrosive
environments such as very close to the ocean and avoid exposure
to extreme temperatures.
Not recommended for use in air temperatures above 48ºC
Extreme Weather Exposure
Never allow the water to freeze in the titanium tank or serious
damage could occur that is not covered under warranty.
On very hot climates over 45ºC, it may not be possible to run
the system at full power due to the excessive heat.
We recommend against use in air temperatures above 48ºC
If the temperature inside the unit exceeds 60ºC, the over heat
safety circuit will operate and shut the machine down to protect
the machine from heat damage. This will be displayed on the
touch screen. The machine will return to normal operation
automatically if the temperature is reduced to a safe level.
If your machine fails to cool after an extreme heat event
contact our support team. It may have vented refrigerant to
reduce pressures for safety reasons. support@icoolsport.com
Positioning
Your Compact unit must be placed on a flat and level surface. It should
not be placed more than 25 meters from your pool. Be sure to place
the pool and chiller on an area that can support the weight of the
bath when full (water is very heavy, 1KG per Litre). It is recommended
that you seek the advice of a qualified engineer or the local council if
unsure.
We suggest that you closely consider the location for your ice bath
and how you will drain your bath or pool.
Airflow
AS with any powerful refrigeration machine it needs plenty of airflow
to operate. You must allow at least 250mm of clear distance front
and back from any obstacle, wall or structure to allow proper airflow.
Please also make sure it is kept away from heat sources of any kind
or your operating costs will increase. You must provide appropriate
ventilation to keep the machine within a safe operating temperature.
Refrigeration machines can not cool if they can not disperse the heat
effectivelyand can not operate safely in a closed space such as a
cupboard or under stairs.
Your machine has over heat safety devices built in but continuous
operation at close to the extreme heat safety setting of 60ºC can
cause long term damage or loss of refrigerant.
Contact support@icoolsport.com if your machine fails to chill
properly after an extreme heat event.
Water Condensation
Your machine is a very powerful refrigeration device. All such devices
produce very cold surfaces that will condense moisture from the air
in humid or damp conditions. This is why all airconditioners need a
drain from the indoor evaporator. Water vapour may condense and
leak from under your chiller. You can place a drip tray under the unit
to catch the water if this is persistant. It is more likely if your machine
is hesating water as the panel at the rear becomes extremely cold.