Prepare For Set Up - iCoolsport 2 Series Owner's Manual

Prepare for set up

To make setup as smooth as possible, please follow
carefully the instructions outlined below. Do not start
your MiPod until you have read this entire owner's
manual. Improper installation or operation may result
in equipment damage not covered by warranty.
Unboxing
We strongly recommend keeping the original packaging of your
unit for as long as your warranty lasts. It can be used if you ever
re-locate the pool and offers you peace of mind for transport.
To unpack, unscrew the bolts from the wooden crate starting
from the top panel, then the sides. First thing to note is to make
sure nothing is missing.
Requirements of the room
Prior to using your Mipod, you must ensure that the area of
the room where the Mipod is installed should not be less than
6 Square Meters (65 Square Feet) for best results. The door
frames should be at least 810mm wide (32 inches) to allow the
Mipod to be easily carried inside.
Extreme Weather Exposure
For best results, the ambient room temperature recommended
for all models should be between 10-25ºC (50º-77ºF).
If using your MiPod in extreme cold temperatures, never allow
the water to freeze or serious damage could occur that is not
covered under warranty. If freezing conditions are expected in
the room where the MiPod is installed, empty the water, add
anti-freeze to the water or turn on the heating mode if your
model has that function to keep water above freezing.
On very hot climates over 45ºC, it may not be possible to
run the system at full power due to the excessive heat. If the
temperature inside the unit exceeds 70ºC, the over heat safety
circuit will operate and shut the machine down.
Min.
300mm
Positioning
Your MiPod pool must be placed on a uniformly flat and level surface.
Be sure to place the pool on an area that can support the weight of
the bath when full (water is very heavy, 1KG per Litre). It is always
recommended that you seek the advice of a qualified engineer or
the local council if unsure. If eventual servicing is required for any
particular reasons, please also make sure that you have easy access
to all side vents and panels. We suggest that you closely consider the
required location for your ice bath prior to filling your bath. Please
account for the attachment point to drain the surplus water. We also
recommend to have a floor drain nearby for easy drainage of your
pool.
Airflow
For models with internal chillers, please ensure your MiPod is
placed at a minimum distance of 300mm on all sides away from any
obstacle, wall or structure to allow proper airflow. Please also make
sure it is kept away from heat sources of any description.
You must provide appropriate ventilation to keep the machine within
a safe operating temperature. A good ventilated area is required so
your chiller can disperse the heat effectively into the air and it should
not be placed in a confined space otherwise it will reach unsafe
temperatures that will cause the inbuilt safety system to operate and
shut down the unit.
Water Condensation
Please note that your unit is a very powerful chiller and
condensation will occur inside of your machine and you may notice
a small amount of water at the base. Condensation is water from
the air being condensed as ice or water on the very cold surfaces of
the iCool's machinery. This is more evident in high humidity where
the air contains a lot of water.
Minimum 300mm
Minimum 300mm
WALL or OBSTRUCTION
Min. 300mm