Important Safety Warnings - iCoolsport 5 Series Owner's Manual

Hide thumbs Also See for 5 Series:
Table of Contents

Advertisement

Important Safety Warnings

POWER SUPPLY VOLTAGE
iCools can only be connected to the voltage marked on
the machine. They are manufactured as either 110v or
220v machines, but they are not multi-voltage. Using a
different voltage may cause severe damage. All models
can be used on both 50 Hz and 60 Hz AC supplies.
ELECTRICAL POWER CONNECTION
The power input socket on the side of your iCool
must be connected to standard AC power capable of
providing at least 13 amps in countries with a 220 V
supply and 26 amps in countries with a 110 V supply.
The iCool requires much less power than this for normal
operation, however all heat pump compressor motors
need considerably more power for up to a minute each
time they start up and this must be allowed for.
AN APPROVED EARTH CONNECTION IS
ESSENTIAL FOR SAFE OPERATION
To ensure safe operation, the AC power connection you
use must have an earth connection that complies with
your local electrical safety regulations.
EMERGENCY STOP
In an emergency, push the ORANGE button on the
MAIN POWER SWITCH or switch off the main power
switch and all high voltage electrical power is removed
instantly from the water pumps and cooling system.
Please be sure all users of the pools are familiar with
this function. Make sure all operators and users know
where the ORANGE button is to remove all power. This
button is located on the Main Power Switch. In most
cases of electrical leakage this function will operate
automatically to remove all power.
ELECTRIC SHOCK PROTECTION
LIMITATIONS
All iCool machines have built-in electrical safety
residual earth leakage protection systems. It can only
protect against devices actually connected to the iCool
including the water pump. It can not protect against
faults in other unrelated electric devices in the area.
All electric devices in any pool area must be connected
to a power supply that also has a residual earth leakage
device either at the main switch board or on the device
itself. Never risk using unprotected electrical devices
near water.
SAFE TEMPERATURE SETTINGS
Following international safety recommendations your
iCool will not accept water temperature settings below
4ºC 39ºF) as this would put athletes using the system
at risk of hypothermia. Also it will not accept heating
temperature settings above 40º C (104ºF) to prevent
any chance of scalding sensitive skin.
Please be careful with prolonged cold or heat exposure.
POOL FENCING & SANITISATION
Please contact your local authorities about pool fencing
and sanitisation compliances. iCoolsport can not be
responsible for local Government health requirements.
Particular care must be taken on all surfaces on or near
baths. iCoolsport can not accept any liability for injury
or death from users slippingon wet surfaces in and
around the ice bath or chilling machine. Please ensure
all users understand the risk of wet slippery conditions.

Advertisement

Table of Contents
loading

Table of Contents