Side-By-Side Installation Instructions; Wine Rack Removal/Installation - U-Line Echelon 2175WC Installation Manual

Side-By-Side Installation
Instructions
For a complete refreshment center, install your 2175WC or
2175WCOL unit beside a U-Line Refrigerator, Ice Maker or
Combo Model (see Figure 11 for typical cut-out). Note
that each Side-By-Side Installation will be different.
• Cut-out width for a side-by-side installation is the total
of the widths listed under Cut-Out Dimensions in each
unit's Installation Guide.
For example:
Placing a 2175 Wine Captain
would require a cut-out width of:
24-3/16" + 15-3/16" = 39-3/8"
Placing a 2175 Wine Captain
would require a cut-out width of:
24-3/16" + 24-3/16" = 48-3/8"
• No trim kit is required. However, 1/4-inch space needs to
be maintained between the units to ensure
unobstructed door swing.
• Units must operate from separate, properly grounded
electrical receptacles placed according to each unit's
Electrical Specifications.
Typical Side-By-Side Cut-Out
34-1/4"
to
35-1/8"
1/4" Space
Between
Appliances
Figure 11
06/2006
2175WC/2175WCOL Wine Captain
®
next to a 2115 series unit
®
next to a 2175 series unit
23-1/4"
7"
1-1/2"
®
4 Prepare Racks and Door Frame
The U-Line Wine Captain
trimmed wine racks that are coated at the factory with a
clear vinyl sealer, which will adequately protect the wood
in normal usage. A final finish coat was not applied so
that the wood trim could be stained to match décor or
overlay frame. The trim on the racks may be coated with a
final finish or stained.
2175WCOL Models are designed for, and require
installation of, an Overlay Frame.
If none of these treatments are to be included in this
installation, go on to 5 Adjust Door.
To prevent permanent damage to the inner liner of the
®
Wine Captain , the wine rack wood trim MUST be
removed from the unit for staining and/or finishing.
Allow stain/finish to dry thoroughly (at least 24 hours per
coat) in accordance with the stain/finish manufacturer's
instructions prior to re-installing the wood trim inside the
cabinet of the Wine Captain
the inner liner of the unit to have a permanent odor,
which is not covered by the warranty.

Wine Rack Removal/Installation

To remove a rack from the cabinet:
1. Grasp the end of the rack, and gently slide it out until
it stops.
2. Remove any bottles stored on the rack.
Figure 12
3. Press the left rack release lever (Figure 12) down, and
at the same time, lift the corresponding right rack
release lever up, and pull the rack out until it is free of
the tracks and the cabinet.
IMPORTANT
Do not remove the track side rails from the cabinet.
7
®
is equipped with wood-
CAUTION
®
. Failure to do so may cause
ULIN_0207_A
www.U-LineService.com