1 Table of Contents Safety Precautions Safety Alert Definitions............................1 General Precautions ..............................1 Inspect & Plan Product Registration .............................2 Models Covered..............................2 Tools / Material Required ............................2 Exterior Cleaning ..............................2 Black and White Models:........................... 2 Stainless Models:............................2 Prepare Site Electrical Specifications ............................3 Cut-Out Dimensions.............................3 2115 Series ..............................
Consult the installation guide before any installation begins. U-Line contact information appears on the rear WARNING cover of this guide. SHOCK HAZARD - Electrical Grounding Required.
Product Registration • Drill & Drill Bits (Optional Door Panel on 2115R(F) or 2175R(F) Black or White Models) You have received a carton containing your U-Line Refrigerator, Refrigerator Freezer, Beverage Center or Wine Captain® unit • 1/4” thick door panel material with a package inside containing a Use and Care Guide, a Product •...
4 Prepare Site 2175 Series Your U-Line product has been designed for either free-standing or Follow the cut-out drawing The 24-1/4" width allows 1/4" for ease built-in installation. When built-in, your unit does not require in installation and removal of the unit. 24" is the cabinet depth in additional air space for top, sides, or rear.
2115R 2115WC(OL) & 2175RC 5 Product Dimensions Series 2115R Series 2115WC / 2115WCOL Series 21175RC/RCG/RF Series 23-1/4" 23-1/16" 23-1/4" 34-1/8" 34-1/8" 34-1/8" 3-13/16” 15" 3-13/16” 15” 3-13/16” 24" 2115R Black / White Models 2115WCS Stainless Steel Models 2175R(C)(F) Black and White Models 23-1/8”...
6 Door Swing Dimensions 2175WC Models Wall Wall 2115R Models 2" Min. Wall Wall 1/4" Min. 2" Min. 21" 21" 21" 21" 25-1/2" 25-1/2" Door Swing Door Swing Stainless Steel Black, White and Wood Overlay 16-1/2" 16-1/2" Door Swing Door Swing Stainless Models Black and White Models Units have a zero clearance for the door to open 90°.
If door edge needs to move down, opposite side of the cabinet. move plate toward inside of door(3). Repeat until top edge of door is parallel with top of cabinet and tighten screws (1) securely. U-Line Self-Closing Door Alignment and Reversal...
Page 10
2. Remove the two door closer inserts (4) from the existing bottom hinge. Align and adjust the door: 3. Install door closer inserts as shown on the new bottom hinge Align and adjust the door, see DOOR ALIGNMENT AND (4). ADJUSTMENT above. U-Line Self-Closing Door Alignment and Reversal...
Allow the final coat to dry for 24 hours before reinstalling Before reloading the rack, ensure proper operation of the travel the trim to the cabinet interior parts. stops in the left and right track rails by pulling the rack out gently until it completely stops. U-Line Wood Trim Finishing...
Remove door by tilting forward and lifting off bottom hinge pin. 2. Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge . This may take some force. U-Line Door Panel Installationl...
You may also mount your overlay to your grille using hook and 10 Wood Grille Overlay loop type fasteners. U-Line recommends using 3M® Dual lock® fasteners. To mount your overlay using a hook and loop fastener follow the instructions below.
Page 14
Grille Drawing 24 inch U-Line Grill Overlay Installation...
1. Use the following instructions to create or have a wood 11 Overlay Frame overlay panel created for you Wine Captain® or beverage Center model as shown below. Frame Preparation 2. Drill holes for pivot pins, upper door hinge and lower door hinge as shown 2115WCOL 2175WCCOL &...
Prepare The New Overlay Panel IMPORTANT IMPORTANT The overlay door panel must not weigh more than 20 lbs. The thickness of the door panel must be 3/4” 1. Place a towel, or similar, soft non-marking material out on a flat clean surface.
Assembling Door To Cabinet 8. Starting at the corners and working toward the center, push the DOOR FRAME door gasket back into place. Make sure the gasket is fully seated on all four sides and corners. TAPE 9. Check the closure assembly on the bottom hinge to be sure it is seated correctly in the bosses in the hinge.
Installation 12 Installation 1. Plug in the powercord. Leveling Information 2. Gently push the unit into position. Be careful not to kink the It is recommended that the unit is level. water supply line or entangle the electrical cord. 1. Use a level to check 3.
E-mail: onlineparts@u-line.com ABOUT U-LINE Building on 45 years, U-Line has captivated those with an appreciation for the finer things with exceptional design, inspired innovations and attention to even the smallest details. U-Line is synonymous with premium built-in undercounter ice making, refrigeration and wine storage appli- ances, the U-Line Corporation is committed to luxury under the counter.
Need help?
Do you have a question about the 2000 SERIES and is the answer not in the manual?
Questions and answers