U-Line Echelon 2175WC Installation Manual page 10

Height: 1-17/32" from top edge of frame (less 1/8" for
depth of notch on top of frame)
Radius of corner notch: 1/8" (see Back View)
4. Drill holes for pivot plate mounts (see Figure 15, Back
View).
5/16" diameter x 1/2" deep, from the routed surface
CAUTION
Be careful not to drill too deep! Drilling holes too deep
may destroy your door frame.
5. Drill hole for upper door hinge (top of frame) (see
Figure 15, Top View).
0.177" diameter
(#16 drill) x 11/16" deep
6. Drill hole for lower door hinge (see Figure 15, Bottom
View).
5/16" diameter x 1/4" deep
CAUTION
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood
when hardware is installed.
Installation Instructions
Preparing Door
Note: Door is not attached. It
is in a separate box inside the
unit box and taped to the
unit.
1. Lay door on a clean, flat
surface with the gasket
facing up.
2. Pull gasket completely out
of the groove. Start in the
middle and pull outward,
moving toward the edge
(see Figure 16). This may take some force.
Note: Lay gasket flat on a clean surface to avoid
disturbing interior magnet.
Checking Overlay Fit
Not Fully Seated
Figure 17
1. Turn door over and lay overlay frame on front side of
door. Make sure frame is fully seated on all four sides.
See Figure 17.
www.U-LineService.com
2175WC/2175WCOL Wine Captain
Gasket
Door
Figure 16
Little or No Gap Objectional Gap
®
2. Visually check for gap between frame and glass. If there
is an objectionable gap, follow steps under Applying
Foam Tape to Overlay Frame. If there is little or no gap,
continue to Attaching the Overlay Frame.
Applying Foam Tape to Overlay Frame (If required)
Incorrect
Figure 18
1. Cut foam tape into four pieces, two pieces the width
of the overlay frame and two pieces the height of the
overlay frame.
2. Remove the adhesive protection strip from one piece of
the foam tape and align to the edge of the overlay
frame as shown in Figure 18, adhering the foam tape
to the overlay frame.
3. Trim each piece of tape immediately after application.
Do not allow any overlapping of the foam tape.
Damage to the overlay frame can occur if the foam tape
is not trimmed properly.
Typical Wood
Frame
Figure 19
Attaching the Overlay Frame
1. Tap nylon inserts into the top holes drilled in the
overlay frame. Use two #6 screws to attach top pivot
bracket to the overlay frame (see Figure 19).
2. If a user-supplied cabinet handle will be used, attach its
hardware to the overlay frame at this time.
10
Inside Edge
Correct
#6 X 5/8"
Flat Head Screw
Two Required
Top Pivot
Plate
8 mm Plug Insert
Two Required
06/2006