If your product registration is not on file and a request for warranty coverage is received, the date of sale to the U-Line Selling Dealer or Distributor will be established as the first date of warranty coverage for your product.
Product Disposal .......................11 Cleaning and Maintenance .....................11 General Cleaning ......................11 Maintenance ........................12 Service ............................18 Before Calling for Service ....................18 If Service is Required ......................18 Replacement Parts ......................18 Troubleshooting Guide ....................19 Electronic Control Quick Guide ..................21 U-Line Corporation Limited Warranty ..................23 CO2175FF, 2175RF...
Page 4
This page intentionally left blank CO2175FF, 2175RF...
• Self-closing door hinges engage when the door is open 4 Product Features approximately 8-10 in. (20-25 cm), ensuring a positive door seal and preventing door bounce back. Échelon Model 2175RF Refrigerator/ • Black and white models feature a slightly contoured, Freezer, Model CO2175FF Ice Maker/ across the top, integrated door handle design that permits the door to be easily reversed.
ULIN_0093_A Initial Startup Figure 4 All U-Line units are shipped with controls that are preset. To check the actual product temperature, in refrigerator No initial adjustments are required. section only, insert an accurate thermometer into a plastic...
Temperature Display Selection 1. Press and release either the WARMER (Figure 6, 2) or U-Line products supplied for 110 VAC operation have COOLER (Figure 6, 4) icon to put the controller in the temperatures displayed in a default Fahrenheit (°F) SET TEMPERATURE mode.
Ice Maker The ice bucket can be removed for emptying and cleaning. To remove the ice bucket, raise the bin arm and When the ice bucket is full, the ice making mechanism will remove the bucket from the ice compartment. Use the ice shut off.
6. Disconnect power to the unit, dry any remaining water Some U-Line models are designed to operate in outdoor, from the ice maker assembly, and reconnect any lines marine and RV environments. For best performance, keep removed from the water supply valve.
Stainless Steel Polish and Cleaner, which can be heavy duty cloth or package sealing tape. purchased from U-Line Corporation (P/N 173348). Comparable products are acceptable. Frequent cleaning will remove surface contamination that could lead to rust.
Maintenance CAUTION Proper maintenance of your U-Line product will ensure DO NOT use any type of cleaner on the condenser efficiency, top performance and long life. The unit. maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you 4.
Page 13
FSP the ice maker assembly as follows: Whirlpool parts. Using non U-Line parts can reduce ice rate, cause water to overflow from ice maker mold, damage the unit, and may void the warranty.
Page 14
Door Alignment Check and Adjustment IMPORTANT IMPORTANT When properly aligned: • The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top. • The door gasket will be firmly in contact with the ULIN_0201_A perimeter of the cabinet and not pinched on the hinge side of the door.
Page 15
Door Reversal ULIN_0002_A Figure 21 2. Remove plastic screw plugs (three each, top and bottom) (Figure 21, 1) from new hinge location. Do not discard. 3. Remove top hinge (three screws) (Figure 20, 2) and reinstall hinge screw pin (Figure 20, 1). ULIN_0015_A Figure 19 Black and white units may be left- or right-hand opening.
Page 16
5. Remove the two door closer inserts (Figure 23, 1) from Door Shelf Removal/Insertion the existing bottom hinge and install as shown on the new bottom hinge (Figure 22, 1). 6. Remove existing bottom hinge (three screws) and remount on opposite side TOP. Remove hinge screw pin. 7.
Page 17
“hump” on the right hand side. temperature control of your unit. 2. Tilt right hand edge of shelf up. 3. Replace the bulb only with a genuine U-Line P/N 31317 replacement. 3. Remove shelf from unit by pulling out.
7 Service Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood. If the malfunction persists, the TROUBLESHOOTING GUIDE...
Troubleshooting Guide DANGER ELECTROCUTION HAZARD Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY Unit does not operate and No electrical supply Plug unit in or check circuit breaker.
Page 20
PROBLEM POSSIBLE CAUSE REMEDY ICE MAKER EQUIPPED MODELS ONLY Water is leaking out the back of the Water supply connection leaking Tighten fitting as required. unit. Ice cubes sticking together Infrequent use of cubes Break apart cubes. No ice Bin arm locked in upright position Lower bin arm.
Electronic Control Quick Guide All Models Task Touch Touch Display Comment Turn ON/OFF Hold 10 seconds Release when °F flashes. °F flashes after first touch, Adjust set-point saved after 5 Temperature seconds of inactivity and °F Touch and release Touch to change temperature stops flashing.* View Actual For Wine Coolers, see Use...
Page 22
This page intentionally left blank CO2175FF, 2175RF...
During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Lines option, repair any product or replace any part of a product that breaches this warranty;...
Page 24
When you need replacement parts, always request genuine U-Line replacements be used. Visit www.U-Line.com to locate a parts distributor in your area. U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in undercounter ice makers, Combo ice maker/refrigerators, Wine Captain wine storage units, ®...
Need help?
Do you have a question about the Echelon Series and is the answer not in the manual?
Questions and answers