Side-By-Side Installation Instructions; Adding A Final Finish Coat To Wood Trim - U-Line 2015WC Wine Captain Installation Manual

™
Side-By-Side Installation
Instructions
For a complete refreshment center, install your 2015WC or
2015WCOL unit beside a U-Line Refrigerator, Ice Maker or
Combo Model (see Figure 11 for typical cut-out). Note
that each Side-By-Side Installation will be different.
• Cut-out width for a side-by-side installation is the total
of the widths listed under Cut-Out Dimensions in each
unit's Installation Guide.
For example:
Placing a 2015 Wine Captain
would require a cut-out width of:
15-3/16" + 15-3/16" = 30-3/8"
Placing a 2015 Wine Captain
would require a cut-out width of:
15-3/16" + 24-3/16" = 39-3/8"
• No trim kit is required. However, 1/4-inch space needs to
be maintained between the units to ensure
unobstructed door swing.
• Units must operate from separate, properly grounded
electrical receptacles placed according to each unit's
Electrical Specifications.
Typical Side-By-Side Cut-Out
34-1/4"
to
35-1/8"
1/4" Space
Between Appliances
Figure 11
02/2005
2015WC/2015WCOL Wine Captain
®
next to a 2015 series unit
®
next to a 2075 series unit
23-1/4"
7"
1"
®
4 Prepare Racks and Door Frame
The U-Line Wine Captain
trimmed wine racks that are coated at the factory with a
clear vinyl sealer, which will adequately protect the wood
in normal usage. A final finish coat was not applied so
that the wood trim could be stained to match décor or
overlay frame. The trim on the racks may be coated with a
final finish or stained.
2015WCOL Models are designed for, and require
installation of, an Overlay Frame.
If none of these treatments are to be included in this
installation, go on to 5 Adjust Door.
To prevent permanent damage to the inner liner of the
®
Wine Captain , the wine rack wood trim MUST be
removed from the unit for staining and/or finishing.
Allow stain/finish to dry thoroughly (at least 24 hours per
coat) in accordance with the stain/finish manufacturer's
instructions prior to re-installing the wood trim inside the
cabinet of the Wine Captain
the inner liner of the unit to have a permanent odor,
which is not covered by the warranty.
Adding a Final Finish Coat to Wood
Trim
1. Remove each wine rack by
sliding it out and up. See
Figure 12.
2. Remove and save screws
securing wood trim to the
racks.
3. Lightly scruff sand the
wood trim with 280 grit
3M Tri-M-Ite sandpaper.
4. Remove sanding dust with
a tack cloth.
5. Apply a thin coat of Minwax Polycrylic, following
container label for directions. Allow to dry 24 hours.
6. Lightly sand, tack and reapply 2 times, if desired.
7. Allow the final coat to dry for 24 hours.
8. Reinstall wood trim to wine racks using screws
removed in Step 2.
9. Reinstall wine racks in unit.
10. For 2015WC units, go on to 5 Adjust Door.
7
®
is equipped with wood-
CAUTION
®
. Failure to do so may cause
Slide Out
and Up
Figure 12
www.U-LineService.com