Maintenance; Problems, Causes And Solutions - Breville Prima Latte III Instructions For Use Manual

function. Let the cleaning cycle run until
you no longer see any milk coming out
of the tube, or let the cycle run until it
stops automatically.
7. Repeat Steps 1 – 6 as necessary using
only tap water to rinse any remaining
traces of vinegar out of the machine.
CLEANING NOTIFICATION
will activate.
1. The Cleaning Indicator Light will remain
procedure is completed.
a. If you brew another espresso.
latte. or cappuccino. the cleaning
light will turn off momentarily, but
of the brew.
b. When the unit is powered off the
Cleaning Indicator Light will turn
off.
c. When the unit powers down
and goes into sleep mode, the
cleaning indicator light will turn off.
CLEANING PROCEDURE
1. Pour a solution of 50% white vinegar
and 50% clean water into the water
tank. Stir the solution with a spoon to
make sure it is properly mixed.
2. Rotate the milk tank knob to the clean
position. Place a large cup under the
frothed milk dispensing tube.
3. Press the clean button for 5 seconds to
activate the deep clean mode.
a. The progress bar slowly cycles,
same as when the brew cycle
is operating, through the entire
cleaning cycle.
b. The pump will turn on and off
multiple times for about 12
minutes. The cleaning light will
then turn off indicating that the
cleaning cycle is completed.
16
4. Pour out any remaining solution from
the water tank and replace with clean
water. Fill with clean water up to the
Max level line.
5. Press the manual Espresso button
"
press the manual espresso button to
stop the machine.
6. Rotate the milk tank knob to the clean
position and press the clean button to
run the normal clean mode.
7. Press the espresso button and then the

MAINTENANCE

This appliance has no user serviceable
parts. Any servicing beyond that described
in the Cleaning Section should be
performed by an Authorized Service
Representative only. See warranty section.

PROBLEMS, CAUSES AND SOLUTIONS

PROBLEM CAUSES
Coffee does not • No water in reservoir.
come out. •
•
• Appliance was not turned on
or plugged in.
• Coffee has been tamped/
compressed too much.
Coffee comes out •
around the edge of lock position.
• Coffee grounds around the
•
Milk is not foamy • Check the froth control
after frothing or it is position.
not coming out of • Ran out of steam.
the frothing tube. • Milk is not cold enough.
• Frothing tube is blocked.
Coffee comes out • Ground coffee is too coarse.
too quickly. •
Coffee is too weak. •
shot of espresso.
• Ground coffee is too coarse.
The control panel • Water reservoir is out of
water.
• Brewing function button was
pressed prior to the progress
bar fully illuminating to show
the machine is ready.
Cleaning light • Your machine is letting
remains on. you know it is ready for
a cleaning cycle to be
performed.
SOLUTIONS
• Add water.
• Grind medium ground coffee.
•
• Plug unit into electrical
outlet and turn it on.
•
and TAMP GENTLY.
•
lock position.
• Wipe off rim.
• Fill with less coffee.
• Ensure there is enough
water in the water reservoir.
• Chill milk prior to making
cappuccino or latte.
• Follow the instructions to
clean the milk reservoir &
frothing tube.
•
•
•
shot of espresso.
•
• Add water to reservoir.
• Wait until the progress bar is
fully illuminated, and a solid
light, to indicate the machine
is ready.
• Perform cleaning cycle (see
page 11).
17