Breville Prima Latte III Instructions For Use Manual page 8

7. Dispose of any water left in the milk
reservoir and place it back in the unit.
You should feel the milk reservoir lock
in place.
DEEP CLEANING THE FILTERS
90 days for optimal brewing performance.
Follow these disassembly instructions and
rinse the pieces in a large bowl of warm
water. Once rinsed thoroughly, wipe dry and
reassemble.
Step1 Step2
Push
Unlock
Lift
Remove
Step3
Remove
Seal
Remove
Filter
CLEANING THE FILTERS
1. To remove the detachable bottom
them counterclockwise towards the
unlock icon " ".
2. Wash the detachable bottom covers
Make sure to rinse and dry them well.
3. Place the detachable bottom covers
in their place and then rotating them
clockwise (away from the unlock icon
" ") until you hear it click.
14
Froth Milk Dispensing Tube Cleaning -
without affecting milk in resorvoir
1. Ensure the milk reservoir and lid are
properly inserted in the unit.
2. Place a large empty mug under the
froth dispensing tube.
3. Turn the Froth Control Knob counter
clockwise to the clean position
" " then press the " " button to
activate the clean function. The unit will
start releasing steam through the froth
dispensing tube. Let the cleaning cycle
run until you no longer see any water
coming out of the tube, or let the cycle
run until it stops automatically.
4. Dispose of the water in the mug.
5. You can remove the milk reservoir with
the lid and store it in the fridge for later
use.
CLEANING THE BREW HEAD, THE
PORTA-FILTER AND FILTERS
1. Press the on/off "I/O" switch located
on the right side of the unit to the off
position "O" and unplug the power cord
from the electrical outlet.
2. Some of the metal parts may still be
hot. Do not touch them with your hands
until they have cooled.
coffee grounds or used pod. Wash both
warm soapy water. Make sure to rinse
and dry them well.
NOTE:
4. Wipe the lower part of the brew head
in the unit with a damp cloth or paper
towel to remove any coffee grounds
that might have been left.
back in the brew head in the unit and
lock it in place.
6. Place a large empty cup under the
7. Plug the power cord into the electrical
outlet. Press the on/off "I/O" switch to
the on position "I". Press the Espresso
" " button once and let the unit brew
with water until it stops automatically.
CLEANING THE WATER RESERVOIR
1. Dispose of the remaining water by
removing the water reservoir and
turning it upside down over the sink.
It is recommended to empty the water
reservoir between uses.
2. Wash the water reservoir and its lid
thoroughly with warm soapy water.
Make sure to rinse and dry them well.
NOTE: Do not wash the water reservoir
or its lid in the dishwasher.
CAUTION: Do not immerse main body of
the appliance or power cord and plug in
water or any other liquid.
CLEANING THE UNIT
1. Wipe housing with a soft wet cloth. Do
not use abrasive cleaners or scouring
in the brew head. This can adversely
affect the seal between the brew head
espresso.
DESCALING
Build-up of mineral deposits in the unit
will affect the operation of the appliance.
Your appliance must be descaling when
you begin to notice an increase in the time
required to brew espresso, or when there is
excessive steaming. Also, you may notice
a build-up of white deposits on the surface
of the brew head.
The frequency of cleaning depends
upon the hardness of the water used.
The following table gives the suggested
cleaning intervals.
SUGGESTED CLEANING INTERVALS
Type of Water Cleaning Frequency
Soft Water (Filtered Water)
Hard Water (Tap Water)
TO DESCALE WATER RESERVOIR:
1. Fill the reservoir with fresh, undiluted
white household vinegar.
2. Allow appliance to sit overnight with the
vinegar solution in the water reservoir.
3. Discard vinegar by removing the
reservoir and turning it upside down
over the sink.
4. Rinse the water reservoir thoroughly
with water and then pouring the water
back out into the sink, repeating this
step twice.
TO DESCALE INTERNAL PARTS:
1. Make sure you descale the inside of
descale steps above.
2. Make sure to switch the on/off button
to the off "O" position and the power
cord is disconnected from the electrical
outlet. Fill the reservoir with undiluted
white household vinegar.
coffee) and place a large empty cup on
top of the drip tray and under the porta-
4. Plug the power cord into the electrical
outlet.
illuminate (Espresso heater and Steam
heater
" "
a solid light, press the automatic espresso
button
" "
pressing the button again. The progress
6. Place a large empty cup (with at least
frothed milk dispensing tube. Fill the
milk reservoir with water and place it
back on the unit. Turn the Froth Control
Knob counter clockwise to the clean
position " " then press the Clean
" " button to activate the clean
15