Table of Contents
Advertisement
Adjustable Upper Shoulder Belt
Anchorage
In the front and second row outboard seats the shoul-
der belt can be adjusted upward or downward to posi-
tion the seat belt away from your neck. Push or squeeze
the anchorage button to release the anchorage, and
move it up or down to the position that serves you best.
Adjustable Anchorage
As a guide, if you are shorter than average, you will pre-
fer the shoulder belt anchorage in a lower position, and
if you are taller than average, you will prefer the shoul-
der belt anchorage in a higher position. After you
release the anchorage button, try to move it up or down
to make sure that it is locked in position.
NOTE:
The adjustable upper shoulder belt anchorage is
equipped with an Easy Up feature. This feature allows
the shoulder belt anchorage to be adjusted in the
upward position without pushing or squeezing the
release button. To verify the shoulder belt anchorage is
latched, pull downward on the shoulder belt anchorage
until it is locked into position.
WARNING!
•
Wearing your seat belt incorrectly could make your
injuries in a collision much worse. You might suffer
internal injuries, or you could even slide out of the
seat belt. Follow these instructions to wear your
seat belt safely and to keep your passengers safe,
too.
•
Position the shoulder belt across the shoulder and
chest with minimal, if any slack so that it is com-
fortable and not resting on your neck. The retractor
will withdraw any slack in the shoulder belt.
•
Misadjustment of the seat belt could reduce the
effectiveness of the safety belt in a crash.
•
Always make all seat belt height adjustments when
the vehicle is stationary.
Second Row Center (If Equipped) And
Third Row Center Seat Belt Operating
Instructions
The second row center (if equipped) and third row cen-
ter seat belts feature a seat belt with a mini-latch plate
and buckle, which allows the seat belt to detach from
the lower anchor when the seat is folded. The mini-latch
plate and regular latch plate can then be stored out of
the way in the headliner for added convenience to open
up utilization of the storage areas behind the front
seats when the seat is not occupied.
1. Remove the mini-latch plate and regular latch plate
from its stowed position in the headliner slightly
behind the second or third row seat.
Mini-Latch Stowage
2. Grab the mini-latch plate and pull the seat belt over
the seat.
Mini-Latch Plate
SAFETY
133
6
Advertisement
Table of Contents
