Table of Contents
Advertisement
134
SAFETY
3. Route the shoulder belt to the inside of the left head
restraint.
Routing The Rear Seat Belt Latch Plate
1 — Seat Belt Latch Plate
4. When the seat belt is long enough to fit, insert the
mini-latch plate into the mini-buckle until you hear a
"click."
Connect Mini-Latch Plate To Mini-Buckle
5. Sit back in seat. Slide the regular latch plate up the
webbing as far as necessary to allow the seat belt to
go around your lap.
Rear Center Seat Belt Buckled
1 — Seat Belt Latch Plate
2 — Seat Belt Buckle
6. When the seat belt is long enough to fit, insert the
latch plate into the buckle until you hear a "click."
Latch Plate And Buckle Connected
7. Position the lap belt so that it is snug and lies low
across your hips, below your abdomen. To remove
slack in the lap belt portion, pull up on the shoulder
belt. To loosen the lap belt if it is too tight, pull on
the lap belt. A snug seat belt reduces the risk of
sliding under the seat belt in a collision.
8. Position the shoulder belt on your chest so that it is
comfortable and not resting on your neck. The
retractor will withdraw any slack in the seat belt.
9. To release the seat belt, push the red button on the
buckle.
10. To disengage the mini-latch plate from the mini-
buckle for storage, insert the regular latch plate
into the center red slot on the mini-buckle. The
seat belt will automatically retract to its stowed
position. If necessary, slide the latch plate down
the webbing to allow the seat belt to retract fully.
Insert the mini-latch plate and regular latch plate
into its stowed position.
Insert Regular Latch Plate Into Mini-Buckle Slot To
Detach
Advertisement
Table of Contents
