Actioncontrol; Usersetcontrol - IAI GO-2400M-PGE-1 User Manual

GO-2400MC-PGE-1 | GO-2401MC-PGE-1 | User Manual (Ver. 1.0)
Supported GigEVision Options: Link Local Address configuration, DHCP configuration, Persistent IP configuration, Stream
Channel Source Socket, Message Channel Source Socket, Command Concatenation, Write Mem, Packet Resend, Event,Event
Data, Pending Ack, Action, Extended Status Codes, Discovery Ack Delay, Discovery Ack Delay Writable, Test Data, Manifest
Table, CCP Application Socket, Link Speed, Heartbeat Disable, Serial Number, StandardIDMode, IEEE1588Support,
UniconditionalAction, ScheduledAction, PrimaryApplicationSwitchover, ExtendedStatusCodesVersion2_0, UserDefinedName,
SingleLink, MultiLink, StaticLAG, DynamicLAG, PAUSEFrameReception, PAUSEFrameGeneration,
StreamChannel0BigAndLittleEndian, StreamChannel0PacketResendDestination, StreamChannel0AllInTransmission,
StreamChannel0UnconditionalStreaming, StreamChannel0ExtendedChunkData

ActionControl

Configure action control settings.
Action Control Item
Action Device Key
Action Selector
Action Group Mask
Action Group Key
Action Queue Size

UserSetControl

Related Topic: Step 7: Save the Settings
Configure user settings.
Note: Settings that can only be configured when image acquisition on the camera is stopped.
User Set Control Item
User Set Selector
User Set Load
User Set Save
Setting
Default
Range
- 0x00
1 ~ 2 1
- 0x00
- 0x00
- 255
Setting
Default
Range
0: Default*
1: User1
0: Default
2: User2
3: User3
- -
- -
Set the action device key.
Select the action.
Set the mask value that creates the action 0 group,
Set the key that executes action 1.
Set the size of action queue.
Select the user settings.
Load user settings.
Save the current setting values as user settings.
- 89 -
Settings List
Description
Description