Fault Status Codes - Prosense Safevader Series User Manual

8- Remove main PCB from PCB holder via releasing the latches.
9- Remove Display module cable from main PCB via unlatching the connector.
10- Safely locate the display cable in to main hole located on main PCB.
11- Install new display module cable to main PCB display connector.
12- Install sensor module in to sensor connections on main PCB.
13- Fix main pcb to enclosure cover.
14- Fix front panel to enclosure body.
15- Power On and check status.

Fault Status Codes:

Fault Message
SENSOR Sensor is in fault condition
ADC ADC circuit is not functioning correctly
CURRENT Detector is not generating analogue output signal
POWER Power input is out of range
CPU RAM RAM fault detected
CPU FLASH Flash error detected
EEPROM EEPROM error detected
CAL DUE Defined calibration period is passed, calibraton needed
RS485 RS485 communication failure
CPU CPU failure
TEST DUE Defined test period is passed, test execution needed
LINE Analogue output is not connected or shortcircuited
TEMPERATURE Sensor temperature error
NO COMM Display communication failure
PRS-UM-SV-EN-Rev1.0-16.12.2022
Fault Description
Table 7: SAFEVADER Series Fault Status Codes
Page 37 / 41