Table of Contents
Advertisement
7-
Install the new sensor module in to main PCB connectors.
8-
Check and replace the filter located on enclosure cover if necessary.
9-
Fix main pcb to enclosure cover.
10-
Fix front panel to enclosure body.
11-
Power On and check status.
The sensor module has been calibrated at Prosense factory and calibration parametrs
12-
are recorded. But if you see any deviation perform full calibration at least 4 hours later or next
day.
Detector Transmitter board replacement:
Prosense detector transmitter is the main logic board including all definitions and configuration.
Hence it is necessary to perform reconfiguration in case of replacement. Hence the spare part
must be ordered by giving the serial number of the detector. The replacement should be done
via following steps:
1-
Power-off the detector via disconnecting power cable from control panel or supply
2-
Use screwdriver to remove 4 screws on front panel
3-
Remove front panel from enclosure body
4-
Use screwdriver to remove screws from PCB holder
5-
Remove enclosure cover.
6-
Remove sensor module from main PCB connectors.
7-
Remove all cable connectors from terminals.
8-
Remove main PCB from PCB holder via releasing the latches.
9-
Install the new main PCB to PCB holder via fixing the latches on holder.
10-
Install sensor module in to sensor connections on main PCB.
11-
Check and replace the filter located on enclosure cover if necessary.
12-
Fix main pcb to enclosure cover.
13-
Fix front panel to enclosure body.
14-
Power On and check status.
The main PCB module parameters recorded at Prosense factory. But if you see any
15-
deviation perform full parameter adjustment and calibration if necessary at least 4 hours later
or nex day.
Display Module replacement:
Prosense display board is a replaceable part. The replacement should be done via following
steps:
1-
Power-off the detector via disconnecting power cable from control panel or supply
2-
Use screwdriver to remove 4 screws on front panel
3-
Remove front panel from enclosure body
4-
Use screwdriver to remove screws from PCB holder
5-
Remove enclosure cover.
6-
Remove sensor module from main PCB connectors.
7-
Remove all cable connectors from terminals.
PRS-UM-SV-EN-Rev1.0-16.12.2022
Page 36 / 41
Advertisement
Table of Contents
