I - Window/Door Open Function; Overheat Protection - Olimpia splendid CALDO UP T WIFI Instructions For Use And Maintenance Manual

3.4.i - Window/Door open function

If enabled, the WINDOW/DOOR OPEN function allows the appliance to detect an
abnormal amount of cold air in the room.
In this condition, when the appliance is in heating mode or in set temperature mode
(the function is cannot be activated in functioning as fan), if it detects an ambient tem-
perature reduction by a few degrees, the function activates.
Each time the appliance is electrically connected, the WINDOW/DOOR OPEN
function is deactivated.
If this function is disabled, the appliance works normally.
Temperature detection starts 1 minute after the open window/door detection.
The function activates with a round which lasts 10 minutes and every 5 minutes the
appliance detects ambient temperature to check if the window/door has been closed.
If, during the checks, the appliance detects:
• a difference of ≤8°C compared to ambient temperature, it keeps heating and the
open window/door detection continues,
• a difference of >8°C compared to ambient temperature, it stops heating and switches
to stand-by mode and the open window/door detection stops.
This function can only be activated through the app.

4 - OVERHEAT PROTECTION

• This heater is protected with overheat protection that switches off the appliance
automatically in case of severe overheating.
In this case:
- unplug the appliance;
- wait about 15/20 minutes for it to cool;
- remove any possible cause of overheating, eg. something covering the heater;
- check for damage to the appliance, the cord and the plug.
• If there is no damage:
- plug the unit back in;
- switch it on as described above.
If the heater still does not turn on, please contact Customer Service for assistance.
CALDO UP T WIFI EN - 15