Remote Control Functions Buttons; Use Of The Remote Control - Olimpia splendid CALDO UP T WIFI Instructions For Use And Maintenance Manual

3.2 - REMOTE CONTROL FUNCTIONS BUTTONS

A remote control to ease the settings and the functions of the appliance is supplied. At
each pressure of a button of the remote control, the appliance emits a "beep" to report
the signal reception. In order to use the appliance it is necessary to press the switch
on the right side of the appliance on "I" (ON) (position 6 - figure X).
ON/OFF button
Press this button to switch the appliance on; the FAN LED turns on, the appliance
starts in FAN mode and the flap opens.
Press it again to switch the appliance off.
Operation mode selection button
Press this button to select the desired functioning mode
Minimum power (LOW) > Maximum power (HIGH) > FAN (FAN)
Flap button (SWING)
Press this button to adjust air direction.
Switching off delay button
Press this button to confirm/cancel the appliance switching off delay.
ECO mode button (temperature setting)
Press this button to set the desired temperature. After pressing the button, set
temperature with buttons
Setting values increase/decrease buttons

3.3 - USE OF THE REMOTE CONTROL

The remote control supplied with the appliance is the
instrument that will allow you to use the appliance in the
most comfortable way possible. It should be handled with
care and in particular:
• Keep it dry (do not clean it with water or leave it out-
doors in bad weather).
• Avoid dropping or bumping it.
• Keep it out of direct sunlight.
• The remote control operates by means of an infrared beam.
• Avoid obstacles between the remote control and the appliance during use.
• If other appliances in the room have remote controls (TV, stereo, etc...), there
may be interference.
• Electronic and fluorescent lights may interfere with the transmissions between
remote control and appliance.
• Remove the batteries in case of prolonged disuse of the remote control.
and (range: 18°C÷45°C).
CALDO UP T WIFI EN - 11