ROLEC Sinexcel ULTRACHARGE 160 Installation & Operation Manual page 8

Safety Instructions for Operation
Do not use this product if the power cord or connector shows any signs of damage.
In case of any abnormal operation or conditions, press the emergency button
immediately to turn off all electrical input and output.
If the emergency button is pressed, the system operator should be informed. The
charging station must not be restarted until the system operation technician resets the
system.
Make sure there is no debris or fluids in the EV charging connector or vehicle inlet.
Do not attempt to connect or disconnect power cables when power is on.
When performing maintenance, turn off the power switch, ensure that electrical
connections are correct, and display warning notices in the area.
Pay attention to the copper wire carries dangerous voltage of equipment, even when
all circuit breakers of the charger are disconnected.
Connect protective earth wire (PE) before connecting neutral line and phase line.
After installation or maintenance, make sure that all doors are correctly secured.
Adaptors or conversion adapters are not allowed be used.
Extension cords are not allowed be used.
UltraCharge 160 DC Charger
Page 7 of 30
EVUCM-001-V01R1 Installation and Operation Manual
October 2023