Table of Contents
Advertisement
8.3. SYSTEM CLEANING INSTRUCTIONS
The power supply and converter may be cleaned using an acid-free cleaning solution
(i.e. glass cleaner).
Probes should be cleaned using isopropyl alcohol. Probes are made from titanium and
can be autoclaved (the converter is an electrical part and cannot be sterilized in this
manner). Before each procedure place the probe tip in water or alcohol and turn the
power on for a few seconds to remove residue. The tip also can be sterilized using alco-
hol with the power on.
9. TROUBLESHOOTING
The most probable causes for malfunction are listed below and should be investigated.
•
A connector or cable is damaged.
•
The probe is not tightened properly with the wrenches provided.
•
The converter and/or probe has been dropped.
•
A probe being operated is damaged or worn past its useful life.
If the problem persists after inspecting all of these, please contact Customer Service
for additional assistance or to replace a worn probe or damaged part.
Advertisement
Table of Contents
