Table of Contents
Advertisement
8.2. ATTACHING & DETACHING PROBES
1.
Disconnect probe from convertor. Use the wrench set provided with the system.
2.
Clean threaded stud. Use alcohol and a cotton swab to remove any debris on the
threading of the connecting stud. Allow the alcohol to dry completely.
3.
Clean threading in converter. Use alcohol and a cotton swab to remove any debris
on the threading. Do not allow liquid to drip into converter. Allow the alcohol to
dry completely.
4.
Re-attach probe to converter. Screw the probe back onto the converter and tighten
with the wrench set provided.
Advertisement
Table of Contents
