Appendix C: Cables And Pin-Outs; Twisted-Pair Cable Assignments; Rj-45 Connector Pin-Out - Enterasys RoamAbout 3000 Installation Manual

Twisted-Pair Cable Assignments

For 10/100BASE‐TX connections, a twisted‐pair cable must have two pairs of wires. Each wire pair
is identified by two different colors. For example, one wire might be green and the other, green
with white stripes. Also, an RJ‐45 connector must be attached to both ends of the cable.
Figure
connectors in the same orientation when attaching the wires to the pins.
Figure C-1
Caution: DO NOT plug a phone jack connector into the RJ-45 port. Use only twisted-pair cables
with RJ-45 connectors that conform with FCC standards.
Precaución: NO utilice un conector de teléfono en el puerto RJ-45. Utilice solamente cable de
par trenzado con conectores RJ-45 para cumplir con los estándares de la FCC.
Achtung: Verbinden Sie keine Telefonkabel mit dem RJ-45-Anschluss. Verwenden Sie
ausschließlich verdrillte Kabel mit RJ-45-Anschlüssen, die den FCC-Standards entsprechen.
Caution: Each wire pair must be attached to the RJ-45 connectors in a specific orientation. (Refer
to "Straight-Through Wiring" on page C-2 and
Precaución: Cada par debe estar adjunto a los contactos del conector RJ-45 en una orientación
específica. Refiérase a "Straight-Through Wiring" y "Crossover Wiring" para una explicación al
respecto.
Achtung: Jedes Kabelpaar muss in einer bestimmten Ausrichtung mit den RJ-45-Anschlüssen
verbunden werden. Weitere Informationen hierzu finden Sie unter „Straight-Through Wiring"
(Standard-Verkabelung) und „Crossover Wiring" (Crossover-Verkabelung).
C‐1 illustrates how the pins on the RJ‐45 connector are numbered. Be sure to hold the

RJ-45 Connector Pin-Out

8
1
Cables and Pin-outs
"Crossover
8
1
RoamAbout Access Point 3000 Hardware Installation Guide C-1
Wiring" on page C-3 for an explanation.)
C