Troubleshooting; Power Cut; Demo Mode - Gaggenau BX 480 Series Use And Care Manual

Troubleshooting

You can often easily eliminate problems that may occur
on your own. Before calling customer service, take into
account the following information.
Disruption
Appliance not working, no display
Appliance cannot be started
Appliance is not working, display is not
0
responding. appears in the display.
Appliance switches off automatically
Appliance does not heat up,
in the display
Error message "Exxx"

Power cut

Your appliance can bridge a power cut of a few
seconds. Operation continues.
If the power cut was for a longer period and the
appliance was in operation, a message appears in the
display. Operation is interrupted.
Set the function selector to
operated again as usual.
Possible cause
Plug not inserted
Power failure
Fuse defective
Operating error
Appliance door is not quite closed
Child lock activated
Safety deactivation: the appliance has
not been operated for longer than 12
hours
°
Appliance is in the demo mode
appears
, then the appliance can be
0
9
WARNING
Risk of electric shock
Improper repairs are dangerous. Only an
authorized servicer may perform repairs and may
replace damaged plug and connections. Remove
the power plug or turn off the circuit breaker or
fuse in the fuse box if the appliance is damaged
or not working. Call Customer Service.
Solution
Connect the appliance to the electricity mains
Check whether other kitchen appliances are
working
Check in the fuse box whether the fuse for the
appliance is in working order
Switch off the fuse for the appliance in the
fuse box and switch it on again after about 10
seconds
Close appliance door
Deactivate child lock (see section entitled
'Child lock')
Confirm the message with
appliance and set it again.
Deactivate demo mode in the basic settings
If an error message appears, turn the program
selection to
one-time problem. If the problem occurs
repeatedly or if the display stops, please con-
tact after-sales service and inform them of the
error code.

Demo mode

The demo mode is activated if the
the display. The appliance does not heat up.
Briefly disconnect the appliance from the mains (switch
off the domestic fuse or the circuit-breaker in the fuse
box). Then deactivate the demo mode within 3 minutes
in the factory setting (see section entitled 'Factory
setting').
™
, switch off the
0 ; if the display goes off, it was a
°
symbol appears in
33