Panasonic HL-G1 Series User Manual page 51

3-3-2 Memory Change
The memory to save setting contents can be changed with M0 through M3.
Setting
M0
M1
M2
M3
*
Select the first number to be changed when the system goes into setting mode.
Data unstability may result when the memory change is executed.
If setting changes are made with a serial communications command, save the
changes so that the changes will be reflected when the system is turned ON again.
1
Display the "Memory Change" screen
while the system is in setting mode.
2
will be displayed.
3
memory changes. (Example: Changing
the memory to "M3".)
4
memory.
Each function that has been set can be saved in four ways in the memory
area in the sensor head.
Measurement and judgment conditions can be saved individually according to the
type of measurement object. Therefore, memory number changes will be possible
without entering the set values for a wide variety of functions.
Memory changes are made with external commands and settings in the control
panel.
Ramco Innovations (800) 280-6933 www.panasonicsensors.com nsales@ramcoi.com
Function
Memory M0
Memory M1
Memory M2
Memory M3
indicates the default value.
Panel display