Panasonic HL-G1 Series User Manual page 115

Error code
Error
Code type
code
01 Command error
02 Address error
03 Data error
04 BCC error
11 Communication
error
21 Control flow error The system is in setting mode.
22 Execution error
31 Buffering
condition error 1
32 Buffering
condition error 2
33 Buffering
condition error 3
If an abnormal response is received, check if there are any errors such as
transmission data errors. Correct such errors, if any. If an error occurs
regardless of the absence of mistakes, it may be a temporal phenomenon
caused by noise or other external reasons or the external host device may
have a system error. Turn the sensor head or system turned OFF and ON.
Ramco Innovations (800) 280-6933 www.panasonicsensors.com nsales@ramcoi.com
Description
The command is undefined.
The start address is larger than the end address or the
address is larger than 999999 when the RDD or WDD
command is executed.
The address length has not reached the prescribed
length when the RDD or WDD command is executed.
The data length does not correspond to the command.
The data length has not reached the prescribed length.
BCC check was not conformable.
A parity error occurred during data reception.
A framing error occurred during data reception.
An overrun error occurred during data reception.
Calibration or analog scaling is not executable.
An attempt was made to make a buffering setting
change without stopping buffering.
An attempt was made to start buffering with an
inadequate buffering setting.
Data was read after buffering operation started.
Data was read while the system was not in the
accumulation completed status.
Data in excess of the final data point was specified and
read.