Panasonic HL-G1 Series User Manual page 33

* Multi-input wire (MI) varies with the period of input as shown below.
Period of input
30 ms
80 ms
130 ms
180 ms
230 ms
280 ms
330 ms
380 ms
430 ms
480 ms
530 ms
580 ms
MI input
Enter MI input for the desired period with a tolerance of ±10 ms (T±10 ms).
Two or more MI inputs can be entered in sequence on the condition that a
minimum interval of 10 ms is set between adjacent MI inputs.
No SD/RD lines are prepared for HL-
The action of NP switching input is determined by the input state of the sensor
head with the power turned ON.
The sensor head does not save setting changes made over the multi-input line.
Save the settings over the multi-input line, through the panel, with the
communications command, or with the operation of the console if the settings
need to be maintained after the system is turned OFF.
Ramco Innovations (800) 280-6933 www.panasonicsensors.com nsales@ramcoi.com
Zero-set ON
Reset
Memory change (M0)
Memory change (M1)
Memory change (M2)
Memory change (M3)
Teaching a (Determines displacement judgment value a)
Teaching b (Determines displacement judgment value b)
Zero-set OFF (Cancel)
Save
Laser ON
Laser OFF
Input time T
Function
-A-C5 standard types.