Troubleshooting - ARIETE 1450 Manual

When all the water inside the water tank is dispensed, the indicator light (
strong coffee button (
- Empty the water tank from the remaining solution.
- Rinse the water tank.
- Fill the water tank with fresh still water up to the MAX level (Fig. 6).
When the appliance reaches the right amount of water into the water tank, the indicator light (
ically turns off.
The descaling process starts again. After several washing cycles and breaks, the descaling process is over
and the appliance automatically turns off.
If the indicator light (
DECOMMISSIONING
When decommissioning the appliance, unplug the power cord from the power outlet, empty and clean the
water tank, the water collection tray, the drip tray and the cup-holder grid (see paragraph "Cleaning and
maintenance of the appliance").
Should the appliance be disposed of, separate the various materials used in the construction of the appliance
and dispose of them according to their composition and the legal provisions in force in the country of use.

TROUBLESHOOTING

Warning!
In case of dysfunctions, immediately turn off the appliance and unplug the power cord from the power
outlet.
PROBLEMS CAUSES
The appliance is not Air has probably entered the
dispensing hot water. circuit and this has deactivated
the pump.
The outlet hole of the steam/hot
water wand (M) is clogged.
The appliance is not There is little water and the pump
delivering steam. suction does not work.
The outlet hole of the steam/hot
water wand (M) is clogged.
The appliance does The plug of the appliance power
not work. cord is not connected to the
power outlet.
The appliance The appliance undergoes
does not respond electromagnetic interference.
to commands or
responds late.
The display is dirty.
Coffee is too watery Coffee grinding is too coarse.
and cold.
If this is the first coffee you are
making, the brewer might be
cold.
The cup used is cold.
16
) start flashing.
) still turns on steady, repeat the descaling process.
) and the indicator light of the
SOLUTIONS
Check the water tank (B) is properly installed and the
water level does not fall below the minimum level indicated
on the tank.
Use the provided needle to remove any scale deposits
from the spout of the steam/hot water wand.
Check the water level in the tank is correct. If needed, fill
the tank with fresh water up to the MAX level.
Use the provided needle to remove any scale deposits
from the spout of the steam/hot water wand.
Plug the power cord into the power outlet and turn on the
appliance.
Check the power cord and plug condition.
Unplug the appliance from the power outlet.
Wait for a few minutes, then plug again the appliance into
the power outlet.
Press the power button (S) to turn on the appliance again.
Clean the display using a non-abrasive cloth.
Try using a finer grinding level.
Perform the manual cleaning cycle of the coffee circuit
(see paragraph "Manual cleaning cycle of the coffee
circuit") for at least three times before making coffee.
) automat-