Troubleshooting - ARIETE Cialdissima 1336 Manual

cleaning the grill and drip tray
remember to empty the drip tray from time to time (C).
Remove the grill (B) and wash it under running water; remove the drip tray (C) from the machine, empty it and wash it under
running water.
cleaning the machine body
Warning!
Clean the fixed parts of the machine using only a damp, non-abrasive cloth so as to not damage the body.
DecAlcIFIcATIOn
Good maintenance and regular cleaning preserve and keep the machine efficient for a longer amount of time, considerably
limiting the risks of lime deposits forming inside the appliance. However, should your coffee machine fail to work properly
as a result of the frequent use of hard, high calcium content water, you may perform a decalcification procedure to restore
its operational efficiency. For this purpose you must use only Ariete's NOCAL, citric acid-based decalcifying products. This
product is easily found at the Ariete technical service centres. Ariete does not assume any responsibility whatsoever for
damage to components inside the coffee machine caused by the use of non-compliant products containing chemical addi-
tives. Should you need to decalcify your appliance, please follow the instructions which come with the decalcifying product.
puTTIng OuT OF serVIce
If you want to put the machine out of service, you must disconnect it electrically, empty the water tank and drip tray and
clean it (see the paragraph on "Cleaning the appliance"). In the case of scrapping, you must separate the various materials
used in making the machine and dispose of them based on their composition and on the legal provisions in force in the
country of use.

TrOubleshOOTIng

Warning!
If there are problems with operation, immediately turn off the machine and unplug it from the socket-outlet.
PROBLEMS
the coffee maker does
not supply boiling
water for tisanes.
Steam overflowing
from the edges of the
filter ring.
the coffee maker does
not supply steam.
16
CAUSES
Air has probably entered the
circuit and deactivated the pump.
The steam exit hole on the
dispenser wand is clogged
You are trying to dispense the
coffee with the steam function
on. Check that the steam
function button has not been
unintentionally pressed.
There is little water and the pump
does not suck it up.
The steam exit hole on the
dispenser wand is clogged.
SOLUTIONS
Make sure the tank is properly inserted and that the water
is not below the minimum level. Repeat the operations
described in the "Preliminary phases for use" paragraph.
Unclog any deposits that may have formed in the hole of
the dispenser wand with a pin.
Stop the coffee delivery. Press the button (T) to cut out
the steam function. Wait for the lamp (S) to turn off before
making another cup of coffee.
Check that the water level in the tank is correct. If neces-
sary, fill it with cool tap water.
Unclog any deposits that may have formed in the hole of
the dispenser wand with a pin.