How To Make Coffee - ARIETE 1450 Manual

- Insert coffee beans (Fig. 9).
Warning!
Only use coffee beans. The use of ground coffee, instant coffee, roasted coffee or any other substanc-
es could damage the appliance.
Do not use an excessive amount of coffee beans.
NOTE: by using a smaller quantity of coffee beans at a time, coffee will always be fresh.
10 Close the coffee beans container lid (W) (Fig. 11).
NOTE: when the indicator light (
First use
Warning!
Before turning the appliance on, make sure the components are correctly installed.
1 Connect the power cord (C) into its seat located at the base of the appliance (Fig. 12).
2 Plug the appliance into the power outlet (Fig. 13).
3 Place a cup on the cup-holder grid (J) (Fig. 14).
4 Press the power button (S) (Fig. 17). The appliance will automatically start a cleaning cycle of the internal
circuits.
Once the automatic cleaning cycle is complete, the appliance will enter the stand-by mode.
NOTE: the automatic cleaning cycle of the internal circuits is not carried out if the appliance stays off
for a short period of time.
To disable the automatic cleaning cycle of the internal circuits, open the lateral door (E) and press the
power button (S) until a sound signal is emitted.
Before using the appliance for the first time, carry out a manual cleaning cycle of the hot water circuit.
- Press the hot water button (
- The appliance starts the cleaning cycle. Wait until water is dispensed from the steam/hot water wand (M).
- Repeat the procedure until consuming all the water into the water tank.
NOTE: repeat this operation every time the appliance is turned on after being left unused for several
days.
Adjusting the height of the dispensing spout and of the drip tray
You can adjust the height of the dispensing spout and remove or adjust the position of the drip tray depending
on the size of the container used.
Slide the dispensing spout upwards or downwards, depending on the size of the cup (Fig. 15).
If you are using a tall mug, slide the dispensing spout upwards and remove the drip tray (Fig. 16).

How to make coffee

1 Place a cup on the cup-holder grid (J) (Fig. 14).
If needed, adjust the height of the dispensing spout as previously described.
2 Press the power button (S) (Fig. 17).
3 Based on the desired coffee strength, press the strong coffee button (
(Fig. 18).
The appliance automatically starts grinding coffee.
The indicator light ( ) will start flashing to indicate the beverage is being prepared.
4 To stop brewing before the process is over, press the coffee button again.
When brewing is complete, the indicator light (
served. The appliance enters the stand-by mode again.
NOTE: when the indicator light (
) turns on steady, the coffee beans container must be filled.
).
) turns on steady to indicate the beverage is ready to be
) turns on steady, the coffee grounds container shall be emptied.
) or the mild coffee button ( )
9